Grizzly G0504 - Manual (Page 25)

G0504 16" Horizontal Resaw Bandsaw -23-
6. Press the UP and DOWN buttons to make
sure the resaw head moves in the proper
direction.
— If the resaw head moves in the opposite
direction as indicated, then the machine
has been wired out of phase. To cor-
rect this, disconnect the power to the
machine, open the electrical box, and
switch any two current carrying wires (R,
S, or T) that connect the machine to the
power source.
7. Push the emergency stop button in, then
twist it clockwise until it pops out.
8. Once you have performed Steps 1-4 and
everything is okay with the machine and
set up, press the MOTOR START button.
As you are standing in front of the machine,
make sure that the blade is moving from left
to right.
9. Press the conveyor lever forward to test the
conveyor belt.
— If any problems occur, press the
EMG STOP button. Investigate and cor-
rect the problem before operating the
machine further. If you need help, refer to
the troubleshooting section in the back of
this manual.
— If you cannot easily locate the source of
an unusual noise or vibration by yourself,
please contact our service department at
(570) 546-9663.
To test run the resaw:
1. Make sure the wheel cover and electrical
box is closed and all tools or other objects
are cleared away from the machine.
2. Put on safety glasses and make sure any
bystanders are out of the way and also wear-
ing safety glasses.
3. Tension the blade.
4. Turn ON the master switch that is located on
the outside of the electrical box.
5. Turn the POWER ON switch (shown in
Figure 21) clockwise.
Test Run
Before starting the resaw, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety issues associated with this machine.
Failure to follow this warning could result
in serious personal injury or even death!
Figure 21. POWER ON switch.