Grizzly G0504 - Manual (Page 26)

-24- G0504 16" Horizontal Resaw Bandsaw
NOTICE
The following section was designed to give
instructions on the basic operations of this
machine. However, it is in no way compre-
hensive of all of the machine’s applica-
tions. WE STRONGLY RECOMMEND that
you read books, trade magazines, or get
formal training to maximize the potential of
your machine.
Damage to your eyes, lungs, and ears could
result from failure to wear safety glasses,
a dust mask, and hearing protection while
using this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause
serious personal inju-
ry. Keep loose clothing
rolled up and long hair
tied up and away from
moving machinery.
All operators of this machine must be familiar
with the
Section 2: Safety before operating
this machine. However, no safety list can cover
every hazard for every working environment, so
common sense must be used at all times in all
situations.
Operation Safety
SECTION 6: OPERATIONS
Conveyor Controls
The Model G0504 features an infeed conveyor
and a return conveyor. The speed and engage-
ment controls of the conveyors are controlled by
the conveyor control lever. The farther the control
lever is pushed forward, the faster the conveyors
will move.
To operate the infeed conveyor:
1. Read the subsection titled “Control Panel”
on Page 14 to become familiar with the con-
trol panel functions.
2. With the saw running, push the infeed con-
veyor engagement lever ( Figure 22) foward
to engage the conveyor belts. Push the lever
farther foward to make the conveyors run
faster, or pull the lever backwards to make
the conveyors run slower. Pull the lever all
the way back to stop the conveyors.
Figure 22. Conveyor controls.
Conveyor Control Lever