Grizzly G0504 - Manual (Page 36)

-34- G0504 16" Horizontal Resaw Bandsaw
3. Replace the drain plug after the hydraulic
tank is completely drained.
To clean the tank screen:
1. Remove the access plate on top of the
hydraulic tank as shown in Figure 33.
Figure 33. Access plate removed from tank.
2. Remove the tank screen, clean it with solvent
and compressed air, and allow it to dry. (Re-
install the tank screen AFTER you clean the
bottom of the tank.)
Tank Screen
Located
Inside Tank
To clean the bottom of the tank:
1. Use a lint free rag to wipe up and remove any
sludge from the bottom of the tank.
2. Use clean hydraulic fluid on a clean rag to
wipe up additional contaminants from the bot-
tom and sides of the tank.
3. Replace the tank screen and access plate.
To fill the tank with new fluid:
1. Make sure that you have re-installed the tank
screen, that the drain plug is tight, and that
you have replaced the access plate on top of
the tank.
2. Using an ISO VG 10—Antiwear 10 Hydraulic
Fluid, fill the tank until the sight window is 2 ⁄
3
full between the hi and low marks on the sight
window. Note—This will take approximately
13.5 gallons.