GE 234D1050P001 User Manual
Page 12
12
Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Remove Door Assembly
2
. Open the door to approximately 130 degrees .
3.
Remove the 2 screws starting from the bottom to the top . Make sure the door
is supported while removing the screws .
4.
Loosen the top screw as shown . Unhook the door by lifting and pulling .
5.
Place the door on a soft protected flat surface so the inner door faces upward (door
resting on handle side) . Remove the 8 tapping screws located around the perimeter of
the door outlining the gasket . Remove the 6 machine screws . Using a putty knife or any
other flat tool, remove the
2
beauty buttons and install them on the opposite side .
Remove
Top Screw
8-#8 Tapping Screws
6-# 8 Machine Tapping Screws
4 Beauty Buttons
Outer Door Assembly
Hinge Assembly
Hinge Cover
Remove Hinge and Cover
IMPORTANT:
Note the location of the hinge (left or right) before removing .
6.
With the screws removed, turn the door over and separate the outer door
assembly and hinge cover of the door from the door frame and set aside .