GE 234D1050P001 - Manual (Page 21)

21
1. Remove the Dryer
Leveling Legs
A. Carefully lay the dryer on its side .
Use the packing material so you
don’t scratch the finish on the dryer .
B. Use an open-end wrench or pliers
to remove the dryer leveling legs .
INSTALLING THE STACK BRACKET KIT
Back out and remove
all 4 leveling legs
2. Install Rubber Pads
to Dryer Base
Locate the 4 rubber pads in the parts
package . Remove the adhesive backing
and firmly place over on the bracket
where you removed the leveling legs .
3. Install Bracket
to Dryer
A. Align the holes in the left bracket
with the holes in the bottom left
corner of the dryer . Use a Phillips
screwdriver to install the 2 #12 x 1″
tapping screws .
B. Repeat the above step with the right
bracket on the bottom right corner
of the dryer .
C. Set the dryer upright .
NOTE: Make sure to set the dryer
on a piece of packing material so
the brackets that are attached to
the bottom of the dryer do not damage
the floor .
GEAppliances.com