Grizzly G0459P - Manual (Page 17)

Model G0459/G0459P (Mfg. 7/11+)
-15-
Mounting
the base of this machine has holes that allow
it to be mounted to a workbench. We strongly
recommend that you mount your machine to
a workbench to prevent it from moving during
operation. an unexpected movement could result
in an injury or property damage.
the strongest mounting option is a "through
Mount" where holes are drilled all the way through
the workbench, and hex bolts, washers, and hex
nuts are used to secure the drum sander to the
workbench.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
figure 5. example of a through mount setup.
Machine Base
Workbench
Lag Screw
Flat Washer
figure 6. example of a direct mount setup.
another option for mounting is a "direct Mount"
where the machine is simply secured to the work-
bench with a lag screw.
installing crank
handle
components and hardware Needed: Qty
Crank handle .................................................... 1
the crank handle is installed on the front right
lift screw shaft, and is held in place with two set
screws already threaded into the handle.
to mount the handwheel, place the crank handle
over the shaft shown in
figure 7 and, using a
3mm hex wrench, secure the handle with the two
set screws.
figure 7. Crank handle installation.