Grizzly G0459P - Manual (Page 21)

Model G0459/G0459P (Mfg. 7/11+)
-19-
basic controls
refer to figure 11 and the following descriptions
to become familiar with the basic controls of this
machine.
A. variable Speed Knob: adjusts feed rate
from 2.47–17.3 FpM. rotate clockwise to
increase feed speed, rotate counterclockwise
to decrease feed speed.
b. hand crank: used to raise or lower the con-
veyor table to control depth of cut. each full
rotation of the hand crank raises or lowers the
conveyor table approximately 0.027" (0.69
mm).
c. On button: turns motor ON.
D. Off button: turns motor OFF.
figure 11. g0459/g0459p controls.
b
C
d
a
figure 13. Minimum lock shaft requirements.
NOTICE
The padlock shaft diameter is important to
the disabling function of the switch. With
any padlock used to lock the switch, test
the switch after installation to ensure that it
is properly disabled.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
disable and lock the switch before leaving
machine unattended! Place key in a well-
hidden or secure location.
Disabling & Locking
Switch
figure 12. switch disabled by a padlock.
The ON/OFF switch can be disabled and locked
by inserting a padlock through the ON button,
as shown. Locking the switch in this manner can
prevent unauthorized operation of the machine,
which is especially important if the machine is not
stored inside an access-restricted building.
IMPORTANT: Locking the switch with a padlock
only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Shaft
Padlock