Grizzly G0459P - Manual (Page 43)

Model G0459/G0459P (Mfg. 7/11+)
-41-
figure 51. Conveyor belt removed from table.
Conveyor
Motor
Cover
Conveyor
Motor
Flat Washer Flat Washer
Left Rear
Roller Bracket
Cap Screw
Cap
Screw
Cap Screws
Table
figure 50. removing conveyor motor and rear
roller bracket (not all components shown for
clarity).
20. remove the rear left roller bracket (2 cap
screws).
21. remove the rear roller.
22. remove the front left roller bracket (2 cap
screws) and the front roller.
23. remove the front right and rear roller brack-
ets (4 cap screws).
24. place the right side of the conveyor on a flat
surface, then unthread and remove the front
and rear table lift screws.
25. remove the belt. the table should look like
figure 51.
26. Measure the distance between the front right
table lift screw sprocket and the mounting
bracket. if necessary, rotate the rear shaft so
the sprocket-bracket distance is the same as
the front right table lift screw.
27. install the new belt.
28. re-install the front left and rear left table
lift screws to match the front right lift screw
height.
29. reassemble the drum sander by reversing
the disassembly steps.
30. after reassembly, adjust the drums and pres-
sure rollers to their proper settings. see Drum
Adjustments on Page 33 and Pressure
Roller height on Page 35.
31. after you have re-installed the conveyor table,
make sure the four lower pressure roller
adjustment bolts are threaded the same dis-
tance into the roller mount brackets (
figure
34).
32. after re-installing the top cover and brace,
tighten the mounting bolts.
18. lay the conveyor table on the edge of a
workbench so the conveyor motor can hang
freely.
19. remove the conveyor motor (4 cap screws)
from the conveyor motor cover, and remove
the conveyor motor cover from left rear roller
bracket (3 cap screws and 3 flat washers).
Front
right
sprocket
Mounting
bracket
rear
lift screw