Grizzly G0555X - Manual (Page 18)

-16-
g0555X (Mfg. since 1/12)
12. remove the table insert from the center of
the table and remove the table pin from the
end of the table slot.
13. Fit the table around the blade and rest the
table trunnions on the trunnion base, making
sure the trunnion bolts are hanging out of the
bottom of the trunnion base.
14. thread the two M10-1.5 knobs onto the trun-
nion bolts hanging through the bottom of the
trunnion base, as illustrated in
figure 12.
Table Trunnion
Table
Trunnion Base
Trunnion Bolt
figure 12. table installation on trunnion base.
15. place the table insert in the center of the
table, so it sits flush with the table top sur-
face.
16. insert the pin into the end of the table slot.
9. attach the lever board to the bandsaw body
with the four spacers and four M8-1.25 x 60
cap screws, as shown in
figure 9.
figure 9. lever body attached.
10. thread the four set screws into the lever
board from underneath until they are flush
with the top of the lever board (
figure 10),
then thread the M8-1.25 hex nuts up the set
screws and against the lever board.
Note: The hex nuts act to lock the set screws
in place once they are positioned, so they do
not vibrate loose during operation.
11. attach the extension table to the lever board
with the four M6-1 x 25 cap screws, four 6mm
flat washers, and four 6mm lock washers
(
figure 11). only thread the cap screws in
halfway for now (adjustments to the exten-
sion table will be made later).
figure 11. extension table installed.
figure 10. set screws installed in lever board
(3 of 4 shown).
set screws Flush w/top