Grizzly G0555X - Manual (Page 29)

g0555X (Mfg. since 1/12)
-27-
the motor switch shown in figure 29 is clearly
marked for starting/stopping the machine.
Motor Switch
the bandsaw table tilts 10˚ left and 45˚ right to
provide a wide range of cutting options.
To tilt the table:
1. loosen the two table-trunnion knobs under-
neath the table.
2. tilt the table to the desired angle. (refer to
the angle gauge on the front table trunnion.)
3. retighten both table-tunnion knobs.
NOTICE
When tilting the table to the left, it is
necessary to remove the positive stop.
Table Tilt
figure 29. Motor switch.
Motor switch
Disabling & Locking
Switch
figure 27. switch disabled by a padlock.
The ON/OFF switch can be disabled and locked
by inserting a padlock through the ON button,
as shown. Locking the switch in this manner can
prevent unauthorized operation of the machine,
which is especially important if the machine is not
stored inside an access-restricted building.
IMPORTANT: Locking the switch with a padlock
only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Shaft
Padlock
figure 28. Minimum lock shaft requirements.
NOTICE
The padlock shaft diameter is important to
the disabling function of the switch. With
any padlock used to lock the switch, test
the switch after installation to ensure that it
is properly disabled.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
disable and lock the switch before leaving
machine unattended! Place key in a well-
hidden or secure location.
0.12"–0.15"