Genie QuietLift 3563435770 - Manual (Page 9)

For Help, call 1-800-35-GENIE or visit www.geniecompany.com
9
NOTE
• Each Remote Control must be programmed separately.
• The Remote Controls will not cause the door Opener to close
the garage door if the Safe-T-Beam® System is malfunctioning.
• When Programming the Remote Controls, they must be at
least 24” from the Antenna Wire.
• If the red Learn Indicator Light blinks approximately 4 times
per second, programming has stopped, repeat the above steps.
• Each Button on a 2 or 3 Button Remote Control is for a
different Opener. You cannot use more than one Button per
Remote, per Opener.
• A maximum of seven Remote Controls or Wireless Keypads
can be stored into the Receiver at one time. If a Remote
Control becomes lost, or if you want to delete a Remote
Control or Wireless keypad, see “To Erase all Receiver Memory”
Figure 3 Genie Remote Controls
1 Button
Remote
w/Flashlight
3 Button
Large
Remote
w/Flashlight
3 Button
Remote
w/Flashlight
Flashlight Button
Frequency
Switch
C Remote Control Operation.
•
Press Button on Remote Control. Garage door will move.
• Press Button again. Garage door will stop:
The door automatically stops at the end of the open or
close cycle.
• Press Button again. Garage door will reverse.
• Some Remote Controls are equipped with a flashlight. The
Genie logo is the button which operates the light. There is a
backlight under the button. When it does not light, it
indicates the battery needs replaced.
AND GO OUT
Figure 4 Erasing the remotes
E Replacing the batteries.
•
Pop off the back of the transmitter using a coin.
• Replace the battery with a new compatable coin
type battery. (size 2032)
• Snap the back of the transmitter on.
CAUTION
Should a remote become lost or stolen it is imperative that
the remote control codes be erased from the receiver
memory and new codes programmed, to prevent the
missing remote from being able to operate the door opener.
NOTE
If the light on the remote glows dimly or does not light
when operating the remote, replace the batteries.
D Erasing all remotes (Figure 4).
•
Press and hold Learn Button on Power Head until Learn
Indicator Light goes out. Memory is erased.
• Program receiver again as needed.
Transmitter Compliance Statement