Quickfreeze, Water filter, About quickfreeze – GE 23 User Manual

Page 9: About the water filter, On some models)

Advertising
background image

About QuickFreeze.

(on some models)

ge.com

The QuickFreeze plate is only to be
used with the QuickFreeze feature.
Use QuickFreeze to freeze items faster
to enhance food preservation.

How to Use

Place food (wrapped in plastic wrap)
on QuickFreeze plate. Turn the feature
on via the LCD controls.

Some LCD Models Only:

Access By: Home > Options > Freezer Options
> QuickFreeze

Activate By: Using the arrows to select
the time and pressing Enter.

Deactivate By: Pressing OFF.

NOTE: While the QuickFreeze feature is
enabled, the actual freezer temperature may
drop as low as –3°F (–19°C). This is normal.

Consumer S

uppor

t

Tr

oubleshooting Tips

Operating Instructions

Safety Instructions

Installation

Instructions

About the water filter.

Water Filter Cartridge

The water filter cartridge is located in
the back upper right corner of the refrigerator
compartment.

When to Replace the Filter

LCD Models:
A pop-up screen will appear on the LCD screen
to remind you to replace the water filter. You can
check the status of the water filter manually.
Access By: Home > Options > Dispenser Options >
Reset Water Filter

Non-LCD Models:
There is a replacement indicator light for the water
filter cartridge on the dispenser. This light will turn
orange to tell you that you need to replace the
filter soon.

The filter cartridge should be replaced when the
replacement indicator light turns red or if the flow
of water to the dispenser or icemaker decreases.

Removing the Filter Cartridge

If you are replacing the cartridge, first remove
the old one by slowly turning it to the left. Do not
pull down on the cartridge. A small amount of
water may drip down.

Installing the Filter Cartridge

There is an adapter attached to the top
of the new filter cartridge.
The adapter must be removed before
installing the cartridge. To remove the
adapter, turn it to the left about 1/4 turn.

Fill the replacement cartridge with water

from the tap to allow for better flow from

the dispenser immediately after installation.

Line up the arrow on the cartridge and

the cartridge holder. Place the top of the new

cartridge up inside the holder. Do not push
it up into the holder.

Slowly turn it to the right until the filter

cartridge stops. DO NOT OVERTIGHTEN.

As you turn the cartridge, it will automatically
raise itself into position. The cartridge will
rotate about 1/2 turn.

Run water from the dispenser for 5 minutes

to clear the system and prevent sputtering.

LCD Models:

Press FILTER REPLACED button to confirm

replacement.

Non-LCD Models:
Press the SET FEATURES pad until REPLACE
WATER FILTER
is lit. Press and hold the
ON/OFF pad for 3 seconds. WATER FILTER
IS RESET
will show in the window.

NOTE: A newly installed water filter cartridge may
cause water to spurt from the dispenser.

Filter Bypass Plug

You must use the filter bypass plug when a
replacement filter cartridge is not available.
The dispenser and the icemaker will not operate
without the filter or filter bypass plug.

Replacement Filters:

To order additional filter cartridges in the United
States, visit our Website, ge.com, or call GE Parts
and Accessories, 800.626.2002.

Filter Model MSWF

Customers in Canada should consult the yellow
pages for the nearest Mabe Service Center.

Place the top of the cartridge up inside
the cartridge holder and slowly turn it
to the right.

QuickFreeze Plate

Filter
Bypass
Plug

SmartWater

Cartridge
Holder

9

Advertising