Grizzly G0621 - Manual (Page 17)

G0621 Wood/Metal Bandsaw
-15-
Figure 10. Fastening front fence rail.
15. Fasten the rear fence rail to the back of the
bandsaw with two M6-1 x 16 cap screws, as
shown in
Figure 11.
14. Fasten the front fence rail to the rail brackets
with the two rail bracket knobs, as shown in
Figure 10, going into the front rail nuts.
10. Place the table insert in the center of the
table, so it sits flush with the table top sur-
face.
11. Insert the pin into the end of the table slot.
12. Attach the rail brackets to the front of the
table with the two M6-1 x 16 cap screws, as
shown in
Figure 9.
Figure 11. Rear fence rail attached to table.
Table Pin
Rear Rail
Figure 9. Rail brackets attached to table.
13. Slide the front rail nuts into the T-slot on the
underside of the front rail.
Rail Brackets
16. Pull the fence handle up and place the fence
on the front fence rail, as shown in Figure
12.
Figure 12. Installing fence onto rails.
17. Push the fence handle down to lock the fence
in position.