Grizzly G0621 - Manual (Page 18)

-16-
G0621 Wood/Metal Bandsaw
18. Use the tilt bracket knob to secure the table
tilt bracket to the bandsaw body, as shown
in
Figure 13. Tighten the hex nut on the tilt
bracket knob against the tilt bracket to secure
it in place.
Figure 13. Knob securing table tilt bracket.
19. Thread the handle into the handwheel, then
tighten the hex nut against the handwheel to
secure it in place.
20. Install the 6" handwheel, as shown in Figure
14, by placing it on the shaft and tightening
the set screw in the handwheel.
24. Carefully install the scale on the front fence
rail, as shown in Figure 15, so the 0" mark on
the scale lines up with the pencil mark made
in
Step 22.
Figure 15. Scale installed on front fence rail.
Figure 14. 6" Handwheel installed.
Set Screw
21. Slide the fence against the blade.
22. Use a sharp pencil to mark the fence rail
where the fence scale indicator is pointing.
This mark will indicate where to align the 0"
mark when you install the scale.
23. Remove the fence from the front rail.
Figure 16. Blade guide installation.
1 ⁄
4
"-20 x 1 ⁄
2
"
Thumbscrews
Guide
Blocks
25. Insert the guide blocks into the upper and
lower blade guide assemblies, then secure
them with the
1 ⁄
4
"-20 x 1 ⁄
2
" thumbscrews, as
shown in Figure 16.
26. Install the dust port, as shown in Figure
17, with the four 10-24 x 1 ⁄
4
" Phillips head
screws.
Figure 17. Dust port installation.
Dust Port
Installed Inside
Cabinet