Genie GS-2668 DC - Manual (Page 21)

Part No. 82750 Genie GS-2668 DC and Genie GS-3268 DC 19
Operator's Manual Third Edition • Third Printing
FUNCTION TESTS
Test Limited Drive Speed
35 Press the lift function select button.
36 Press and hold the function enable switch on the
control handle.
37 Slowly move the control handle in the direction
indicated by the blue arrow. Raise the platform
approximately 8 feet / 2.4 m from the ground.
38 Press the drive function select button.
39 Press and hold the function enable switch on the
control handle.
40 Slowly move the control handle to the full drive
position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
0.73 feet / 22 cm per second.
If the drive speed with the platform raised exceeds
0.73 feet / 22 cm per second, immediately tag and
remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
41 Fully lower the platform.
42 Drive both wheels on one side onto a 4 inch /
10 cm block or onto a curb.
43 Raise the platform approximately 8 feet / 2.4 m
from the ground.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute.
44 Push the drive select button.
45 Move the drive control handle in the direction
indicated by the blue arrow, then move the drive
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
46 Lower the platform and drive the machine off the
block.