Self-cleaning, Self-cleaning , 19, Using the self-cleaning oven – GE 164D4290P024 User Manual

Page 18

Advertising
background image

18

Consumer Support

Troubleshooting T

ips

Care and Cleaning

Operating Instructions

Safety Instructions

Using the self-cleaning oven.

Before a Clean Cycle

We recommend venting your kitchen

with an open window or using a

ventilation fan or hood during the first

self-clean cycle.
Remove the shelves, broiler pan, broiler

grid, all cookware and any aluminum foil

from the oven.
The oven shelves can be self-cleaned,

but they will darken, lose their luster

and become hard to slide.
Soil on the front frame of the range and

outside the gasket on the door will need

to be cleaned by hand. Clean these areas

with hot water, soap-filled steel-wool pads

or cleansers such as Soft Scrub®. Rinse

well with clean water and dry.

Do not clean the gasket. The fiberglass

material of the oven door gasket cannot

withstand abrasion. It is essential for the

gasket to remain intact. If you notice it

becoming worn or frayed, replace it.
Wipe up any heavy spillovers on the oven

bottom.
Make sure the oven light bulb cover is in

place and the oven light is off.

IMPORTANT:

The health of some birds is

extremely sensitive to the fumes given off

during the self-cleaning cycle of any

range. Move birds to another well

ventilated room.

Wipe up heavy soil on the oven
bottom.

How to Set the Oven for Cleaning

Touch the SELF CLEAN pad.
Using the number pads, enter the

desired clean time, if a time other

than 4 hours is needed.

Clean cycle time is normally 4 hours.

You can change the clean time to any

time between 3 hours and 5 hours,

depending on how dirty your oven is.

Touch the START pad.

The door locks automatically. The display

will show the clean time remaining. It will

not be possible to open the oven door

until the temperature drops below the

lock temperature and the LOCKED DOOR

light goes off.
When the LOCKED DOOR light is off, open

the door.
The oven shuts off automatically when

the clean cycle is complete.

The words LOCK DOOR will flash and

the oven control will signal if you set

the clean cycle and forget to close the

oven door.

To stop a clean cycle, touch the
CLEAR/OFF

pad. When the LOCKED

DOOR

light goes off indicating the

oven has cooled below the locking

temperature, open the door.

Advertising
This manual is related to the following products: