GE 164D4290P024 - Manual (Page 24)

24
Consumer Support
Troubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Cleaning the glass cooktop.
Turn off all surface units. Remove
hot pans.
Wearing an oven mitt:
a.
Use the razor scraper to move
the spill to a cool area on the
cooktop.
b. Remove the spill with
paper towels.
Any remaining spillover should be
left until the surface of the cooktop
has cooled.
Don’t use the surface units again
until all of the residue has been
completely removed.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
Damage from Sugary Spills and Melted Plastic Our testing shows that if
you are cooking high sugar
mixtures such as jelly or
fudge and have a spillover,
it can cause permanent
damage to the glass surface
unless the spillover is
immediately removed.
Be careful not to slide pots and
pans across your cooktop. It will
leave metal markings on the
cooktop surface.
These marks are removable using
the cleaning cream with a scrub
sponge and/or razor scraper.
If pots with a thin overlay of
aluminum or copper are allowed
to boil dry, the overlay may leave
black discoloration on the
cooktop.
This should be removed
immediately before heating again
or the discoloration may be
permanent.
WARNING: Carefully check the bottom of
pans for roughness that would scratch
the cooktop.
Metal Marks and Scratches
To order Cerama Bryte® cream and
the razor scraper, please call our
toll-free number:
National Parts Center 800-626-2002.
Cerama Bryte ® Cream . . . . . . .# WX10X300
Razor Scraper . . . . . . . . . . . . .# WX5X1614
Kit . . . . . . . . . . . . . . . . . . . . . .# WB64X5027
(Kit includes cream and razor scraper)
To Order Parts
Glass surface – potential for permanent damage .
To clean the cooktop seal around the
edges of the glass, lay a wet cloth on it
for a few minutes, then wipe clean with
nonabrasive cleaners.
Cooktop Seal