Broiler pan & grid, Light, Shelves – GE 164D4290P024 User Manual

Page 22: Care and cleaning of the range

Advertising
background image

22

Consumer Support

Troubleshooting T

ips

Care and Cleaning

Operating Instructions

Safety Instructions

Care and cleaning of the range.

Oven Heating Elements

Do not clean the bake element or the broil
element. Any soil will burn off when the
elements are heated.

To clean the oven floor, gently lift

the bake element. Clean with warm

soapy water.

Oven Shelves

Clean the oven shelves with an abrasive

cleanser or steel wool. After cleaning,

rinse the shelves with clean water and dry

with a clean cloth.

To make the shelves slide more easily,

apply a small amount of vegetable oil

or cooking oil to a paper towel and wipe

the edges of the oven shelves with the

paper towel.

Broiler Pan & Grid

Do not clean the broiler pan or grid in a self-
cleaning oven.

After broiling, remove the broiler pan

from the oven. Remove the grid from the

pan. Carefully pour out the grease from

the pan into a proper container.
Wash and rinse the broiler pan and grid

in hot water with a soap-filled or plastic

scouring pad.

If food has burned on, sprinkle the grid

with detergent while hot and cover with

wet paper towels or a dishcloth. Soaking

the pan will remove burned-on foods.
Both the broiler pan and grid may be

cleaned with a commercial oven cleaner.
Both the broiler pan and grid can also be

cleaned in a dishwasher.

After broiling, remove the broiler
pan from the oven. Do not store a
soiled broiler pan and grid anywhere
in the range.

Storage Drawer Removal

To remove the drawer:

Pull the drawer out until it stops.
Lift the front of the drawer until the

stops clear the guides.
Remove the drawer.

To replace the drawer:

Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push

back until the stops clear the guides.
Lower the front of the drawer and

push back until it closes.

Stop guide

Rail

Oven Light Replacement

CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the range at the main fuse or
circuit breaker panel.

Be sure to let the light cover and bulb

cool completely.

To remove the cover:

Hold a hand under the cover so it

doesn’t fall when released. With

fingers of the same hand, firmly

push back the wire cover holder.

Lift off the cover.

Do not remove any screws to remove the cover.

Replace bulb with a 40-watt

appliance bulb.

To replace the cover:

Place it into groove of the light

receptacle. Pull wire forward to

the center of the cover until it

snaps into place.
Connect electrical power to

the range.

Wire cover holder.

NOTE: The oven shelves may be cleaned
in the self-cleaning oven. However, the
shelves will darken in color, lose their
luster and become hard to slide if cleaned
during the self-cleaning cycle.

Advertising
This manual is related to the following products: