GE AZ85H12DAC - Manual (Page 15)

Installation Instructions
15
TYPICAL UTILITY CLOSET AND DIMENSIONS
(FOR REFERENCE ONLY)
Side View
Top View
Architectural Louver
10”
duct Door/access panel
5” min.
5” min. Unit front
3”
min.
14” min. – Required only if optional
Hydronic Heating Kit (RAVHW1, RAVHW2,
RAVHW3) is to be installed. Clearance
for installation should be taken into
consideration if this kit is to be used.
Exterior/Outside
Outside wall
Wall
plenum
Inside wall
Air discharge
outlet
Rigid
ductwork
Flexible or
rigid duct
Wall plenum
divider
31”
Option 1
Access panel with
return air grille
Option 2
Return air grille
Filter bracket
Secure platform
to the floor
Platform: 23 1 ⁄
4
” x 23 1 ⁄
4
” square
Min. load capacity: 175 lbs.
• 4" min. from front of case – Unit
installed through FRONT of case.
• 5" min. from front of case – Unit
installed through SIDE of case.
• 3" min. from two sides of case.
(5” for side install).
Plenum
cutout
32 1 ⁄
4
” H
x 20” W
Drain fittings 3 ⁄
4
”
Outside wall
Platform
Wall plenum
Field supplied
outer flashing
10”
11 1 ⁄
2
”
A
B
A Minimum recommended access door width: 30 ”
B Minimum recommended access door height: 50 ”
UNIT INSTALLED THROUGH SIDE OF CASE
Top View
Architectural Louver
10"
duct
Door/access panel
3" min.
4" min. Unit
front
3"
min.
10”
11 1 ⁄
2
”
UNIT INSTALLED THROUGH FRONT OF CASE
Bottom of case approx. 2”
above bottom of plenum
8”min.
for drain
access
Bottom of case approx. 2”
above bottom of plenum
Unit