Grizzly VS MILLING MACHINE G0669X - Manual (Page 19)

g0669X precision 10" x 54" Vs Milling Machine
-17-
2. position the lifting straps under the ram, as
shown in figure 10, with padding between
the straps and the mill to protect the ram
way.
3. Lift the mill slowly to make sure the hook and
lifting straps are secure and the mill is lifting
evenly. Lift the mill only enough to clear the
shipping pallet and floor obstacles.
— if the mill tips in one direction, lower the mill
to the ground, then adjust the ram or table
to balance the weight. re-tighten all locks
before lifting the mill again.
— if the mill lifts evenly, move it to its perma-
nent location.
Note: Have your assistants steady the load
as you move it to keep it from swinging.
4. Use a precision level to make sure the table
is level. shim between the base and the floor
as necessary to avoid warping or cracking
the cast iron base.
Only use lifting safety hook, chain or lifting
straps, and power lifting equipment rated for
at least 4000 lbs. and in good working con-
dition. Only raise the mill enough to clear
shipping pallet and floor obstacles. If the
mill falls or tips over while moving it, serious
personal injury and property damage could
result.
although not required, we recommend that you
mount your new machine to the floor. Because
this is an optional step and floor materials may
vary, floor mounting hardware is not included.
Whichever option you choose, it is necessary to
level your machine with a precision level.
bolting to Concrete floors
Lag shield anchors with lag bolts and anchor
studs (
figure 11) are two popular methods for
anchoring an object to a concrete floor. We sug-
gest you research the many options and methods
for mounting your machine and choose the best
that fits your specific application.
Mounting to Shop
floor
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
figure 11. typical fasteners for mounting to
concrete floors.
Lag shield anchor
and Lag Bolt
anchor stud
NOTICE
We strongly recommend securing your
machine to the floor if it is hardwired to the
power source. Consult with your electrician
to ensure compliance with local codes.