Grizzly VS MILLING MACHINE G0669X - Manual (Page 42)

-40-
g0669X precision 10" x 54" Vs Milling Machine
Coolant Reservoir
Coolant is a potent and
extremely poisonous
solution to humans and
animals. use personal
protective equipment
when handling coolant
to prevent infections or
poisoning.
a small amount of coolant is lost during normal
operation. Check the coolant reservoir regularly
and fill it if necessary.
Checking/Adding Coolant
tools Needed Qty
phillips screwdriver ........................................... 1
to check/add coolant:
1. disConneCt the MiLL FroM poWer!
2. Clean away debris and grime from the res-
ervoir screen on the base of the mill, then
remove it to inspect the level of coolant.
3. if the level of coolant is more than 2" below
the top of the reservoir, add more coolant to
fill the tank.
4. replace the reservoir screen and make sure
the fluid return hose is secured in position.
NOTICE
Running the coolant pump without adequate
coolant in the reservoir may permanently
damage the coolant pump motor. this is
considered abuse and is not covered by the
warranty.
the coolant reservoir on this mill is designed
to store only coolant. During storage some
fluids grow dangerous microbes, or, due
to the collection of toxic metal chips in the
fluid, the fluid can become a potent and
extremely poisonous solution to humans
and animals.
use the correct personal protection equip-
ment when handling coolant to prevent
infections and poisoning.
follow federal, State, and the coolant manu-
facturer's requirements to properly dispose
of used coolant.