GN National Electric CP - Manual (Page 41)

22618-4-1106 Page 41
PEDESTAL INSTALLATION INSTRUCTIONS
Optional Pedestal Assembly Installation
1. Remove pedestal assembly from carton. Handle pedestal
with care to avoid paint damage.
2. Place pedestal assembly into position where heater is to be
located.
3. Lift and place main body of heater on top of pedestal assem-
bly and align main body of heater with locating tabs provided
on pedestal assembly (refer to diagram).
NOTE: To avoid accidents and damage to main heater body and
paint-work, it is recommended that main body of heater
should be located on top of pedestal assembly by 2 peo-
ple.
4. Secure pedestal assembly to main body of heater with three
(3) 1/2”- 10 x 24 screws supplied (refer to diagram).
Note: Use the three (3) 1/2”- 10 x 24 screws and washers provided to secure
pedestal assembly to base of heater.
Figure 50
SCREW
HOLE
SCREW
HOLE
LOCATOR
SLOT
LOCATOR
SLOT