Operations, Mandrels & bits, Operation rules – Grizzly T10165 User Manual
Page 8
Model t10165 high-precision Mini rotary tool
-6
-
operations
operating this tool can propel objects
into the air that may cause eye damage.
to protect yourself from this hazard,
alWays wear ansi approved safety
glasses or goggles during operation.
mandrels & bits
your mini rotary tool is supplied with two
threaded mandrels that hold that hold the
abrasive cones. to install an abrasive
cone onto a mandrel, screw the threaded
tip of the mandrel into the bottom of the
cone.
note: The cones with yellow bottoms are
coarse abrasives, and the ones with blue
bottoms are a medium abrasive.
to install a mandrel or bit:
1. disCoNNECt tool FroM poWEr!
2. press and hold the spindle lock to keep
the spindle from rotating, then loosen
the collet nut (see
figure 2).
figure 2. Model t10165 controls.
Collet Nut
spindle lock
rotary speed dial
3. Fully insert the mandrel or bit shank
into the collet until it stops, then re-
tighten the collet nut.
note: Only tighten the collet nut until
the mandrel or bit cannot be removed
when you tug on it. Overtightening may
damage the components.
operation rules
follow these rules to ensure a safe and
efficient operation:
•
turn the rotary speed dial to
OFF
before connecting the tool to power.
•
to prevent injuries from tool slippage,
alWays secure the workpiece in a
vise or other clamping device. NEVEr
hold the workpiece by hand during
operation.
•
For efficient control of the tool, start
your operation with the slowest speed,
then increase the speed as needed.
•
to avoid the tool slipping in your hand,
make sure your hands are clean and
dry.
•
to prevent excessive wear of the motor
components, NEVEr operate this tool
for longer than five continuous minutes.
turn it
OFF after this time and allow it
to cool for five minutes.
•
to ensure a good finish, ease the cone
or bit into the workpiece. Jamming it
into the workpiece may damage the
tool components or the workpiece.
•
When using the abrasive cones, use
the tip of the cone. otherwise, the abra-
sive material may unravel.