Garmin POWERLITE CINEMA 200+ - Manual (Page 51)

51
Cleaning and Replacing the Air Filter
Clean the air filter on the bottom of the projector after every 100 hours of use. If it’s not
cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can
cause overheating and damage the projector.
1. Turn off the projector and wait for the P power light to stop flashing.
2. Unplug the power cord and disconnect any cables.
3. Turn the projector over. Use a small vacuum cleaner
designed for computers and other office equipment to
clean the filter, as shown. If you don’t have one, gently
clean the filter using a very soft brush (such as a clean
artist’s paintbrush).
If the dirt is difficult to remove or the filter is broken,
replace it. To purchase a filter, contact your dealer or call
Epson at (800) 463-7766 to find an Epson authorized
reseller or visit http://www.epsonstore.com (U.S. sales
only). Request part number
V13H134A04 . In Canada,
call (800) 463-7766 for dealer referral.
4. If you need to replace the filter, release the tab and lift
the cover up.
5. Remove the old filter and replace it with a new one.
6. To replace the cover, insert the tabs and press down until the cover clicks into place.
PowerLite Cinema 200+.book Page 51 Thursday, August 18, 2005 2:37 PM