Garmin POWERLITE CINEMA 200+ - Manual (Page 53)

53
5. Loosen the two screws securing the lamp.
6. Grasp the lamp as shown and pull it straight out.
7. Gently insert the new lamp and tighten its screws.
Caution: Don’t touch the glass portion of the lamp assembly. Touching the glass could
result in premature lamp failure.
8. Replace the cover and tighten its screws. (The projector won’t work if the lamp cover is
open or loose.)
9. Reset the lamp usage timer, as described in the next section.
Resetting the Lamp Usage Timer
After replacing the lamp, follow these steps to reset the lamp usage timer:
1. Press the Menu button on the projector or remote control.
2. Use the menu navigation buttons to open the Reset menu, then select Lamp-Hours
Reset .
3. When you see a confirmation prompt, highlight Yes and press the button.
4. When you’re finished, press the Menu button to exit.
The lamp usage timer doesn’t register until you’ve used the lamp for at least 10 hours.
PowerLite Cinema 200+.book Page 53 Thursday, August 18, 2005 2:37 PM