GE Monogram ZMC1090BV - Manual (Page 9)

Frameless
cabinets
Frameless
Use the information in this dimension drawing for
typical frameless cabinets. The front face of the oven
will be flush with cabinetry doors or drawers.
Whenever possible, order 27" frameless cabinet with
the cutout sized to fit the oven. If you are using stock
cabinets, additional finished filler pieces may be
required to cover openings.
Rough opening for single and double ovens:
• Depth—23-5/8" min. from inside back to front of
cabinet or side panel, excluding doors or drawer
fronts.
– If the cabinet is not 23-5/8" deep, the back of the
cabinet should be cutout. The cutout should be
minimized in order to maintain structural strength
and squareness of the cabinet.
• Width—25" min.
– Frameless cabinet inside width may be up to
25-3/4". Add 1/2" cleats to the sides, flush with
the front edge of the side panels to accept
mounting screws.
• Height—for double oven 49-11/16" min.
• Height—for single oven 27-1/2" min.
Both single and double ovens require 7/8" overlap
around edges of opening on both sides and bottom.
Allow 1/4" for top overlap.
• Allow 1/8" clearance between top of oven and
cabinet door or panel and 1/8" between bottom of
oven and cabinet drawer.
• Installation of double oven requires a total height of
51" including clearances at top and bottom.
• Installation of single oven requires a total height
of 28-13/16" including clearances.
Cabinetry
Built-In Ovens
9