Grizzly G0516 - Manual (Page 17)

G0516 Lathe/Mill -15-
Install Backsplash Mount Mill/Drill
Eyeshield
To install the backsplash:
1. Get the help of an assistant.
2. Hold the backsplash against the back of the
lathe so all of the mounting holes are
aligned, and instruct your assistant to secure
the back splash with the (2) M6-1 X 10 cap
screws as shown in
Figure 7, and (2) M8-
1.25 X 15 hex bolts and washers as shown in
Figure 8.
Figure 7. Two cap screws secure the left-hand
side of the back splash to the lathe.
Figure 9. Attaching eyeshield to the
mill/drill head.
Figure 8. Two hex bolts/washers secure the
right-hand side of the backsplash to the lathe.
To mount the mill/drill eyeshield:
1. Attach the eyeshield to the mill/drill with the
knurled knob as shown in
Figure 9. Note—
the eyeshield provides the best coverage
when it is positioned down as far as it can go.