Grizzly G0516 - Manual (Page 37)

G0516 Lathe/Mill -35-
Figure 57. Removing drill chuck from spindle.
Figure 58. Installing optional collet chuck.
7. Remove the draw bolt from the drill chuck
arbor and thread it into the mill arbor.
Note—
use the flats on the draw bolt to loosen or
tighten it in the arbors.
8. Firmly insert your collet chuck into the spin-
dle taper.
9. Insert the flat washer and thread the hex nut
onto the end of the draw bolt.
6. Hold the drill chuck with one hand and
remove the draw nut and washer with the
other hand. The drill chuck should now be
easily removed from the bottom as shown in
Figure 57. 10. Hold the collet chuck in place with the span-
ner wrench and tighten the hex nut on the
draw bolt just enough to snug it in place. See
Figure 58. DO NOT tighten the hex nut too
tight or the collet chuck will be hard to
remove from the spindle taper.