Grizzly G0516 - Manual (Page 20)

-18- G0516 Lathe/Mill
SECTION 6: LATHE OPERATIONS
Keep loose clothing out
of the way of machinery
and keep hair pulled
back during operations.
NOTICE
The following section was designed to give
instructions on how to prepare the various
items of your
LATHE during operation pro-
cedures; however, this section is in no way
designed to instruct on lathe techniques or
machining skills. WE STRONGLY RECOM-
MEND that you read books, trade maga-
zines, or get formal training to gain the
skills needed to operate the lathe portion of
your machine.
Your safety is important! Please follow the
warnings below during this entire section:
Never leave a chuck key in the chuck when
it is not in use. If the machine is accidental-
ly started, the chuck key can become a pro-
jectile and cause serious personal injury.
Operating this equipment has the potential
for flying debris to cause eye injury. Always
wear safety glasses or goggles when oper-
ating equipment. Everyday glasses or read-
ing glasses only have impact resistant lens-
es, they are not safety glasses. Be certain
the safety glasses you wear meet the appro-
priate standards of the American National
Standards Institute (ANSI).
Figure 13. Lathe controls.
FWD/REV Switch
ON/OFF Switch
Lathe/Mill
Selector Switch
Carriage Feed Lever
To get the most out of your machine, please take
the time to familiarize yourself with the various
controls and components of the mill/drill, as
shown in
Figures 13 and 14.
Figure 14. Lathe components.
Lathe
Lathe Chuck
Compound Slide
Saddle
Cross Slide
Apron
Tailstock