Grizzly G0516 - Manual (Page 32)

-30- G0516 Lathe/Mill
15. Tighten the adjustable shafts and the gear
bracket cap screw. At this point, all gears
should not be able to move out of position.
16. Turn the the chuck by hand to make sure that
all the gears turn smoothly.
17. Replace the drive cover and secure it with
the knurled knobs.
18. Test run the lathe to make sure it works prop-
erly before continuing with your specific
operation.
Reverse Threading
The Model G0516 can be setup to turn left-hand-
ed threads by adding another fixed-shaft gear
and moving the original fixed-shaft gear to anoth-
er mounting location.
Figure 44 shows the three
mounting locations for fixed-shaft gears (spindle
drive pulley is removed for clarity). For illustration
purposes, we label these mounting positions A, B
& C.
Figure 44. Fixed-shaft gear mounting positions.
Figure 45. Extra fixed-shaft gear.
To set up the gears for reverse threading:
1. Disconnect the lathe/mill from the power
source!
2. Locate the extra fixed-shaft gear (shown in
Figure 45) in your inventory of loose parts.
A
B
C