GE JKP17 - Manual (Page 30)

OPERATING THE SELF-CLEANING OVEN
(continued) .
How to Set Oven for Cleaning
Quick Reminder:
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean
1. Prepare the oven for cleaning. cycle is set. The words “ON” and “LOCK” will
2. Close the oven door completely.
appear in the display when the door automatically
locks. It
not be possible to open the oven door
3. Press the CLEAN pad.
until the temperature drops below the lock
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
the oven is too hot and you start to set a clean
cycle, the word “OFF” will appear in the display.
Allow additional time for cooling before you try
to set the cycle.
1. Follow the directions to prepare the oven for
cleaning.
2. Press the CLEAN pad.
CLEAN
3. Press the or
DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You
can change the Clean Time to anywhere
between 2 and 4 hours, depending on
how dirty your oven is.
temperature the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE: You can find out when the
STOP
clean cycle will be finished by
TIME
pressing the STOP button.
The word “door” will be displayed, the word “LOCK”
will flash and oven control will signal if you set the
clean cycle and forget to close the oven door.
To Stop a Clean Cycle
CLEAR
OFF
1. Press the pad. 2. Wait until the oven has cooled below locking
temperature. You will not be able to open the
door right away unless the oven temperature is
at a safe level.
30