GE JKP17 - Manual (Page 37)

PROBLEM
NUMBER FLASH
IN THE DISPLAY
OVEN WILL
NOT WORK
OVEN LIGHT DOES
NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST OR BAKE
PROPERLY
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR WILL
NOT OPEN
OVEN NOT CLEAN
AFTER CLEAN CYCLE
“door” APPEARS
IN THE DISPLAY
APPEARS
IN THE DISPLAY
POSSIBLE CAUSE
●
This is the function error code. Press the CLEAR/OFF pad. Allow oven to
cool 1 hour. Place oven back into operation. If function error occurs again,
disconnect power
to the oven and for service.
●
The circuit breaker in your house has been tripped, or a fuse has been blown.
●
Oven controls not properly set.
* Light bulb is loose or defective. Tighten or replace.
Button oven light is broken. Call for service.
●
The oven controls are not properly set. See the Broiling section.
●
The door not left open to the broil stop position as recommended.
●
Improper shelf position being used.
●
Food is being cooked on a hot pan.
Cookware is not suited for broiling.
●
Aluminum foil used on the broiler pan grid has not been fitted properly
and slit as recommended.
●
The oven controls are not properly set. See the Baking or Roasting section.
●
Shelf position is not correct.
●
Incorrect cookware of improper size is being used.
A foil tent was not used when needed to slow down browning during roasting.
●
The oven thermostat needs adjustment. See the Adjust the Oven
Yourself section.
●
Temperature is too high to set self-clean operation. A11ow the oven to cool, and
reset the controls.
●
Probe is in oven. Remove the probe.
Oven must below locking temperature.
Oven controls not set properly. Review Operating the Self-Cleaning Oven section.
Heavily soiled ovens require 3 to 4-hour Clean Time.
●
Heavy should be cleaned up before starting clean cycle.
●
Oven door not closed after self-clean cycle selected.
●
Door is still locked and you are trying to enter an oven cooking operation.
Oven is too hot for Self-Clean.
Bake or Broil attempted too soon after Self-Clean.
●
Child Lockout feature turned on.
(continued next
37