Stovax 705088 - Manual (Page 20)

20
SERVICING INSTRUCTIONS
REPLACING PARTS
9.3 Undo the two screws at the back of the firebox and carefully
withdraw the bracket.
9.4 Disconnect the two slender wires. Undo the two taptite
screws and remove the sensor and the two plastic spacers.
See diagram 16.
9.5 Refit the new sensor, ensuring that the plastic spacers are
between the sensor and the bracket. Refit the leads. See
Diagram 17.
9.6 Feed the cable back through the hole as you replace the
bracket. When the bracket is located correctly it will sit
flush with the back panel without force required. If not
positioned correctly the bracket will sit at an angle. See
Diagram 18.
10. PRIMARY AERATION PLATE
10.1 Turn the gas supply off at the isolation device.
10.2 Refer to Section 2 to remove the main burner.
10.3 Remove the two screws on the burner skin to detach the
venturi cover from the venturi. Slide the venturi cover off the
venturi as per diagram 19.
10.4 Change the aeration plates to those stated in the technical
specification for the gas the product will be using, refer to
the databadge.
AR1607
15
AR1446
16
AR1608
19
AR1452
17
AR1448
18
AR1447
AR0619
20