Stovax 705088 - Manual (Page 6)

6
7.2 Place log B on the left-hand side of the burner with the
location bar on the underside of the log fully located in the
long slot of the burner. Make sure the log is as far to the left
as possible. See diagram 4.
7.3 Place log C on the right-hand side of the burner with the
location bar on the underside of the log fully located in the
long slot in the burner. Make sure the log is as far right as
possible. See diagram 5.
7.4 Place log D across from the rear log A to log B on the left-
hand side. There are cut-outs in both logs for location. See
diagram 6.
7.5 There are two ash panels which lay across the front of the
burner skin. Place the panel with the flat edge facing the left
side of the firebox. There are location holes on this log
which fit over the screw holes of the burner skin.
7.6 Place the second ash panel to the right of the first, with the
pointed end of the panel fitting into the V shape. This panel
should locate on the screw holes of the burner skin. Ensure
that both logs are horizontal to the burner ports.
7.7 Place log E across from the rear of log A to log C on the
right-hand side. Again, there are cut-outs for location. The
front of the log should sit on the front ash panels and should
fit tight to log C. See diagram 9.
USER INSTRUCTIONS
4
AR1611
5
AR1612
6
AR1613
7
AR1614
8
AR1615
9
AR1616