Grizzly G0671 User Manual

Page 24

Advertising
background image

-22-

Model G0671/G0672/G0673 (Mfg. Since 1/13

4. attach the four casters to the legs by thread-

ing them into the bottom of the legs, as
shown in

figure 11.

x4

figure 11. attaching casters.

Note: The Model G0673 is a three-phase
machine. If it is wired out of phase, the
machine may not function properly. Proceed
to

Test Run on Page 25 to determine if your

machine is wired in phase, then proceed to

Step 7.

The Models G0671 and G0672 are single
phase and cannot be wired out of phase. For
these models, continue below.

7. attach the inlet to the top of the impeller

housing with the #10-24 x 3/8" phillips head
screw, as shown in

figure 13.

5. With assistance, turn the entire assembly

over so that the casters rest on the floor.

6. use eight

5

16

"-18 x 1" hex bolts, (16)

5

16

" flat

washers, and eight

5

16

"-18 hex nuts to attach

each collector to the impeller housing with a
rubber gasket between the components, as
shown in

figure 12.

figure 13. inlet mounted on impeller housing.

phillips

head screw

Caster

leg

figure 12. Collector mounted to impeller

housing.

rubber gasket

Collector

5

16

"-18 x 1"

hex Bolt

5

16

"-18

hex nut

5

16

" Flat Washers

impeller

housing

Advertising