Grizzly G0514 - Manual (Page 24)

-22-
G0513 Series Bandsaws
Installing Fence (G0513, G0513P,
G0513ANV, G0513X2, & G0513X2F)
1. attach the rear rail to the table with the
(2) M6-1 x 16 cap screws, as shown in
Figure 20.
2. attach the front rail with the (2) M6-1 x 20 hex
bolts, 6mm lock washers, and 6mm flat wash-
ers, as shown in
Figure 20.
3. install an M8-1.25 hex nut on the fence
handle, then thread the handle into the fence
assembly, as shown in
Figure 21. tighten
the hex nut against the fence pivot block to
secure the handle.
Figure 21. handle installed on fence assembly.
hex
Nut
pivot Block
4. thread the M6-1 hex nut onto the rail pad,
then thread the rail pad into the rear of the
fence (see
Figure 22).
Figure 22. installed rail pad.
rail pad
hex Nut
5. pull the fence handle up and place the fence
assembly on the front rail (see Figure 23 for
an example photo).
Figure 23. Example photo of correctly installed
fence.
6. push the fence handle down to lock the fence
assembly in place.
7. adjust the rear rail pad until there is an even
gap between the bottom of the fence and the
table, then tighten the rail pad hex nut against
the fence.
Figure 20. rail installation.
rear rail
Front rail
x 2
x 2