Grizzly G0514 - Manual (Page 30)

-28-
G0513 Series Bandsaws
3. loosen the right strain relief on the junction
box, then feed the cord into the box with
enough slack in the wires to make the con-
nections.
4. re-tighten the strain relief around the cord.
tug on it to make sure the wires inside the
box will not move.
5. Connect the incoming ground wire to the
ground post, as shown in Figure 36.
6. secure the two incoming hot wires to the
black and white wires from the bandsaw
with wire nuts, then wrap the nuts and wires
with electrical tape to make sure they will not
come loose.
7. re-attach the junction box cover.
Power Supply Junction Box
R
S
E
Ground
From
Power Supply
To
Bandsaw
Strain
Relief
Ground
Figure 36. incoming power cord connections.
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following: 1)
the motor powers up and runs correctly, and 2)
the safety disabling mechanism works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 57.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure that you have successfully com-
pleted the Initial Blade Tracking procedure
on Page 25 before continuing.
2. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
3. Make sure all tools and objects used during
setup are cleared away from the machine.
4. Connect the machine to the power source.
5. test the operation of the machine to verify
that it starts and operates correctly.
G0513, G0513P, G0513ANV, & G0513X2
Only
a. Verify that the machine is operating cor-
rectly by pressing the power button.
— When operating correctly, the
machine runs smoothly with little or
no vibration or rubbing noises.
— investigate and correct strange or
unusual noises or vibrations before
operating the machine further. always
disconnect the machine from power
when investigating or correcting
potential problems.
Test Run