Grizzly G1016 - Manual (Page 10)

A. Stand
Note: All die-cut metal parts have a sharp
edge (called “flashing”) on them after they are
formed. This is removed at the factory.
Sometimes, though, a bit of flashing might
escape inspection. Please examine the edges
of all die-cut metal parts before handling
them.
TOOLS REQUIRED: Common hand tools
are necessary to assemble this machine. You
will need a set of open ended metric and stan-
dard wrenches and a Phillips head screwdriv-
er.
VII. Assembly
Hunter’s Meat Cutting Bandsaw - 7 -
1. Flip the top of the stand upside down and
place it on your benchtop.
2. Attach the sides using the carriage bolts,
washers, and nuts provided. Mount the
stand front (the side with the switch) so it
is on the same side as the rectangular
hole in the stand top. Figure 2. Do not
fully tighten the nuts.
3. Mount the braces between the front and
back panels. Use carriage bolts, wash-
ers, and nuts provided. Tighten partially.
4. Press the 90° brackets onto the bottom
corners of the stand. These are stiffen-
ers.
Primary Motor
Bracket
Motor
Motor Pulley
Rubber Foot
90° Bracket
Aux. Motor Bracket
Left Brace
Back
Front
Right Brace
Switch
Stand Top Hole
1 st page of 5 page section
Figure 2 shows the stand/motor assembly completed.