Grizzly G1016 - Manual (Page 13)

- 10 - Hunters Meat Cutting
Bandsaw
E. Table
Before installing the table and
guards, peel off the blue, protective
plastic.
Slide the table on at a 45° angle. Figure 6.
Lower the table so the notch goes around the
column. When it is in its final position, secure
it to the bandsaw body using the black knobs
provided.
F. Fence & Guards
Fence:
Install the fence so the vertical portion is fac-
ing the blade. Figure 7. Secure it to the table
and bandsaw body with the black knobs.
Column Guard:
Attach the column guard to the vertical col-
umn. Use the black knobs. Figure 7.
Upper Wheel Guard:
Attach the upper wheel guard to the vertical
column using a black knob. Figure 7.
Blade Guard:
Using the last 2 black knobs, secure the blade
guard to the upper wheel guard.
You may
need to place washers behind the heads of
the knobs so the threaded ends do not touch
the blade. Extra washers are not provided.
Figure 7.
VII. Assembly
Figure 6 shows how to install the table.
Figure 7 shows the fence, guards, and table installed
correctly.
Notch
Blade Slot
Column
Column
Guard
Fence
Upper Wheel Guard
Blade Guard
Table
4 th page of 5 page section