Grizzly G1016 - Manual (Page 9)

VI. Piece Inventory
- 6 - Hunters Meat Cutting
Bandsaw
With all the parts removed from the
container, you should have:
• Bandsaw Unit with Blade
• Motor
• Motor Pulley
• V-Belt
• Table
• Fence
• Column Guard
• Blade Guard
• Table & Guard Knobs (13)
• Stand Parts (5)
• Stand Enclosures (2)
• Motor Mounting Brackets (2)
• Meat Grinder
• Plastic Pestle
• Casing Tube
• Fasteners
If anything is missing, call or write the cus-
tomer service department. If anything is dam-
aged, please follow the procedures described
in Section V above.
Below is a list of fasteners required to assem-
ble your bandsaw. If any standard hardware is
missing (e.g., a nut or bolt), we will be happy
to replace it, but it would be quicker to buy
replacements from your local hardware store.
However, if an unusual amount of fasteners or
proprietary parts are missing, please let us
know. A full parts list and breakdown can be
found toward the end of this manual.
QTY.
22
30
34
4
4
3
4
DESCRIPTION
5 /
16
" - 18 x 5 /
8
" Carriage Bolts
5 /
16
" - 18 Hex Nuts
5 /
16
" Flat Washers
Foot Assemblies
5 /
16
" - 18 x 3 /
4
" Hex Bolts
3 /
8
" - 16 Threaded Studs
90° Brackets
LOCATION
Stand
Stand
Stand
Stand
Motor
Stand/Bandsaw Body
Stand
End of Section
Figure 1 shows the bolt bag contents.