Gateway 8450R User Manual
Page 75
74
Replacing and Adding Internal Devices
2
On the back panel, check the hot-swap status indicator for the card you
are replacing or the slot you are filling. If the slot has power, (the first
LED is green) disable the card through software before replacing it.
3
Remove the back top panel according to the instructions in “Removing
the back top panel” on page 28.
4
Open the hot-swap expansion card retention clip, by pressing gently on
the clip and rotating it through the back panel.
GREEN = Power to slot
AMBER = Fault on slot
Both Lights = Power to slot and Fault condition
Blinking GREEN = Power Up or Down Cycle
Hot-plug Status LEDs
Green and Amber LED’s
Press here
then rotate
Inside View
Outside View
Closed
position
Open
position
8506284.book Page 74 Thursday, July 13, 2000 11:43 AM