Genie INTELLIG 1000 3024 - Manual (Page 16)

©2010 The Genie Company 12/2010 16
3. Press the same button twice
to toggle IntelliCode®
selection from IntelliCode® 2
to IntelliCode® 1.
INTELLICODE® FEATURES
Other models of Genie® garage door openers,
remotes, and wireless keypads use
IntelliCode® 1 signals to communicate. Remote(s)
provided with this unit will transmit either
IntelliCode® 1 or IntelliCode® 2 signals.
Remote(s) contained in this package are preset
to IntelliCode® 2 and can be configured to
communicate with previously installed
IntelliCode® 1 openers. This dual IntelliCode®
option allows one IntelliCode® 2 remote to operate
different models of The Genie Company garage
door openers.
This new Genie® garage door opener will ONLY
accept signals from a remote sending IntelliCode®
2 signals (see page 9) or a Genie® brand
IntelliCode® 1 remote that has been programmed
to the opener using a new IntelliCode® 2 remote
(see page 10).
NOTE: Other remotes not enabled with Genie®
IntelliCode® 2 will not operate this opener.
If you have ...
Use this
IntelliCode®
programming
One or more IntelliCode® 2
openers with a maximum 3
different openers Use IntelliCode®
2
Mixture of openers
manufactured between 1997
and 2010 (IntelliCode® 1) and
new IntelliCode® 2 openers Use IntelliCode®
2 and/or 1
One or more openers
manufactured between 1997
and 2010 (IntelliCode® 1) Use IntelliCode®
1
NOTE: A maximum of 3 different openers can be
programmed to a 3 button remote.
Programming remote to previously installed
IntelliCode® 1 Genie® garage door openers
Remotes provided with this unit can operate other
(IntelliCode® 1) models of Genie® garage door
openers. The default IntelliCode® 2 setting must
be changed to IntelliCode® 1. (Follow these same
steps to change IntelliCode® 1 back to IntelliCode®
2.)
The LED color displayed on the remote indicates
the IntelliCode® mode.
Red = IntelliCode® 1 / Green = IntelliCode® 2
1. Select a button on the remote that has NOT been
programmed to the
new powerhead.
2. Press and hold that
button for 10 seconds.
Both Red and Green
LEDs come ON and stay
ON.
10 SECS
4. Press the same button again
to confirm toggle. The
IntelliCode® selection for this
button is set to IntelliCode® 1.
5. Take the remote to the older Genie® garage door
opener and follow that opener's instructions to
program a new remote.
Repeat for other Genie® garage remote(s) as
necessary.
Red LED Green LED
Three button
remote
ATTENTION
If you have another garage door opener that does NOT have
a Serial Number like this, then you will be using the
INTELLICODE® 1 setting on your remote to operate that opener.
If your garage door opener has a Serial Number sticker which
looks like this, in which the first two numbers are 10 or higher,
your opener is equipped with INTELLICODE®2.
MODEL AC SR3 THE GENIE COMPANY
FCC ID: B8Q AC SR3 Residential Door Operator
IC: 2133A-CSD1D 120V. 60HZ. 5A
FOR HELP CALL 1-800-35GENIE OR WWW.GENIECOMPANY.COM
S/N:10XXXXXXXXXXXX