GE Island Vent Hood ZV421 ZV541 - Manual (Page 17)

17
Installation Instructions
STEP 11 INSTALL FILTERS
• Insert the filter into the upper opening and drop into
the trays.
• To remove the filters, grasp the knobs and push the
filter up and lift out.
STEP 12 INSTALL RODS
• Use a flat blade screwdriver to install stand-offs into
the bottom of the hood.
• Align implement rod to stand-offs with the screw hole
towards the inside of the hood. Secure the rod to the
stand-offs with the supplied Allen wrench.
• Follow the same procedure on the opposite side.
• Place filter drip trays into the rear of the hood.
Screw
Stand-offs
Into Hood
Use Allen
Wrench to
Secure Rod
to Stand-offs
STEP 10 SLIDE DUCT COVER
DOWN
SKIP THIS STEP IF USING THE SUPPLIED DUCT
COVER
• Hold the duct cover in place and remove the
temporary stop screw. Return the screw to the
storage location for future use.
• Slide the lower duct cover down onto the hood.