Grizzly COMBINATION SANDER G1183 - Manual (Page 20)

-18-
model g1183/g1276 (mfg. since 3/10)
Assembly Mounting
the base of this machine has holes that accept 5 ⁄
8
"
bolts for mounting the machine to a workbench.
We strongly recommend that you mount your
machine to a workbench to prevent it from moving
during operation. an unexpected movement could
result in an injury or property damage.
the strongest mounting option is a "through
mount" where holes are drilled all the way through
the workbench, and hex bolts, washers, and hex
nuts are used to secure the drill press to the work-
bench.
Machine Base
Workbench
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
figure 10. example of a through mount setup.
Machine Base
Workbench
Lag Screw
Flat Washer
figure 11. example of a direct mount setup.
another option for mounting is a "direct mount"
where the machine is simply secured to the work-
bench with a lag screw and flat washer.
To assemble the sander:
1. unthread the screw cap on the sanding
belt table lock lever, remove the lever, then
unthread the lock bolt and flat washer from
the sander (see
figure 12).
2. position the belt table trunnion against the
side of the belt housing so that the semicircu-
lar flange fits into the keyway, then secure the
trunnion in place with the lock bolt that was
removed in
Step 1 (see figure 13).
3. re-install the lock lever onto the lock bolt.
figure 12. sanding belt lock lever.
lock Bolt
& Flat Washer
lock
lever
screw
Cap
figure 13. sanding belt table trunnion installed.
table
trunnion
lock
Bolt
Flange
& Keyway