Grizzly COMBINATION SANDER G1183 - Manual (Page 31)

model g1183/g1276 (mfg. since 3/10)
-29-
refer to figures 37–40 for examples of sanding
operations that are possible with the belt sanding
assembly.
figure 37. sanding workpiece in horizontal
position.
figure 38. example of end grain sanding.
figure 39. example of vertical miter sanding.
figure 40. examples of vertical face and edge
sanding.
Sanding workpieces with high-resin content
or with applied finishes can quickly con-
taminate the sandpaper beyond the point
where it can be properly cleaned. This
will produce poor sanding results. In this
case, use a different workpiece, remove the
applied finishes, or frequently clean/replace
the sandpaper strip.
Always sand with the workpiece supported
by the table. Relying only hands to sup-
port the workpiece increases the risk of
workpiece "kick-out" and impact/abrasion
injuries.