Mr Handsfree Blue Vision II - Manual (Page 6)

GB - 3
20. Digital keypad
21. Memo card
22. Memo card protection film
23. Removable battery insulation film
24. Lithium-Polymer battery
25. Battery cover
26. Infrared transmitter
GETTING STARTED GETTING STARTED
The mr Handsfree Blue Vision II is compatible with most Bluetooth ® mobile phones.
Since devices with Bluetooth ® technology communicate through radio waves, your carkit and your mobile phone do not need to be in
direct line-of-sight. The 2 devices only need to be within a maximum of 10 meters of each other, so you do not need to take your phone
out of your pocket or bag to make and receive calls via the carkit.
Since Bluetooth
® phones produced by different manufacturers provide various functionalities; some functions described in this user’s
manual could be different or may not be available.
ACTIVATING THE REMOTE CONTROL
Open the battery cover (25) and take out the insulation film (23). J Install the battery (24) with observance of polarity. J Close the
battery cover (25). Now the remote control is ready to use.
Important!
The remote control and the carkit are connected via an infrared channel. Please make sure that the infrared transmitter (26)
and the receiver (12) are directed towards each other during operation.
CHARGING THE BATTERY
The mr Handsfree Blue Vision II comes with a Lithium-Polymer rechargeable battery. The battery is charged preliminary, but neverthe-
less we recommend charging it before using the carkit for the first time.
Plug the adapter jack into the charging socket (9) and the cigarette plug into the cigarette lighter. J The battery status indicator (11) will
light red or green when the charging process begins. J If the indicator (11) lights red, the carkit should be charged until the indicator
(11) will light green. J Unplug the vehicle charger from the carkit.
Note:
•
You can use the Blue Vision II during the charging process.
• The Blue Vision II is compatible with Nokia mobile phone travel chargers. So you can use them to charge the Blue Vision II at home.
TURNING THE CARKIT ON/OFF
To turn on the carkit, press and hold the Power button (4) for 5 seconds until the battery status indicator (11) will light green and you
will hear a melody tone. J The battery status indicator (11) will start to flash. J To turn off the carkit, press and hold the Power button
(4) until you will hear a melody tone and the battery status indicator (11) will turn off.
INSTALLATION INSTALLATION
MAIN UNIT
On the sun visor: Fix the main unit on the sun visor using the special clip (c) and direct the microphone beam (8) to your mouth. This
is the main working position of the microphone beam: the microphone beam should be rotated from the main unit and its end should
be directed to your mouth.