Mr Handsfree Blue Vision II - Manual (Page 7)

GB - 4
On the dashboard: Fix the main unit on the dashboard using the double-sided tape and the metal flat clip for dashboard fixation (d).
For optimum performance, the microphone should be located at distance of 30-50 cm from the drivers’ mouth.
Note:
We advise not to change the microphone position during the activated call, since an echo effect could appear. If you follow this advice,
you will have a comfortable duplex communication mode of your phone conversation.
REMOTE CONTROL
To fix the remote control on the dashboard, you should remove the memo card (21) from the backside of the remote control. After this
card has been removed, you can fix the remote control on the dashboard using Velcro (6). Make sure that the remote control infrared
transmitter (26) is directed towards the infrared receiver (12) of the main unit and both units are in line of sight of each other.
PAIRING PAIRING
You are required to pair the Blue Vision II with your mobile phone before using it.
Your Blue Vision II can store pairing information for up to 2 different Bluetooth
® telephones. When an attempt to pair more than 2
devices is made, the oldest paired device is removed from the memory.
When any of the paired devices is in the range of 10 meters and the Blue Vision II is turned on, the Blue Vision II will automatically
initiate a connection with the last mobile phone it was connected to. In case this phone is not available, the Blue Vision II will
automatically search for the second paired phone for connection. The Blue Vision II can have one active connection.
Make sure that your phone and the carkit are switched on. J Press and hold the Pairing button (7) for 5 seconds until you hear a
melody tone and the indicator (11) flashes by green and red colors alternately. The pairing mode is now activated for two minutes
(during these 2 minutes, the indicator (11) will keep on flashing). J Enter your phone’s Bluetooth
® menu and make sure that the
Bluetooth ® feature is activated. J Enter the submenu where you can set the phone to search for Bluetooth ® devices and start the
search. J The phone will search all Bluetooth ® devices within 10 meters and display them as a list. J Select Blue Vision II from the
list. J Enter the passkey “0000” to pair and connect the Blue Vision II to your phone. J The indicator (11) will stop blinking and “Blue
Vision II” appears in the phone menu where you can see the Bluetooth
® devices that are currently paired with your phone.
CONNECTION
In some cases the Blue Vision II can be disconnected from your phone and you will need to restore the connection.
•
If the Blue Vision has been switched off: Switch on the power and the connection will be restored automatically.
• If the mobile phone has been switched off: Turn on the mobile phone and restore the connection via the phone’s menu.
• If one of the two devices has been out of range: Make sure that both devices are within working range and press the Connection
button (7) once.
Note:
For all mobile phone types, it is recommended to set “Trust” or “Authorized” for Blue Vision II in the Bluetooth
® menu of your mobile
phone. Please refer to the manual of your mobile phone for more detailed information.
DISCONNECTION
You can disconnect the carkit from your phone when, for example, you want to use another Bluetooth ® device with your phone. The
Blue Vision II can be disconnected in the following ways:
1. Switch off the carkit.
2. Disconnect the carkit in the phone’s menu.
3. Move the phone more than 10 meters away from the carkit.