Mr Handsfree Blue Vision II - Manual (Page 8)

GB - 5
OPERATION OPERATION
Before using the mr Handsfree Blue Vision II make sure that:
•
The carkit is paired and connected to your phone.
• The phone’s Bluetooth ® feature is on; see your phone’s user’s manual.
• The carkit is switched on and the battery status indicator (11) is blinking.
MAKING A CALL
Using your mobile phone’s keypad
Dial a number on the keypad. J Press the phone’s Talk button.
Using voice dialing
When no call is in progress, press the Talk button (5) or the Talk button (14) on the remote control once. J You will hear a tone that
indicates that you can say the desired name (“voice tag”). J Say the voice tag. J The phone plays the voice tag and dials the related
phone number.
You can also activate voice dialing with your phone. For details on voice dialing, please refer to your phone’s user’s manual. Please
note that the voice dialing function is only available if it is supported by your mobile phone.
Using the digital keypad on the remote control
Press the keypad buttons to compose the number (for “+”, you should press and hold the * button until you hear a confirmation beep).
J Press the Talk button (14) on the remote control to start the call.
Using speed dialing
Speed dialing allows you to set a single-digit number for the telephone numbers you call most. You only have to select the speed dial
number to dial the corresponding telephone number. The Blue Vision II can store up to 10 speed dial numbers.
Programming speed dial numbers
Press and hold the “OK” button (19) on the remote control for 2 seconds until you hear a double beep tone. J Press a button from “0”
to “9” to select the memory location where you would like to store the telephone number. You will hear a double beep tone. J Enter
the telephone number using the digital keypad. J Press the “OK” button (19) to confirm the number or press the Reject button (15) if
you don’t want to save the number. You will hear a double beep tone. JThe telephone number you have entered will now correspond
to the selected speed dial number.
Note:
•
You can write the names for the recorded speed dial numbers on the back side of the remote control where the corresponding
memo card (21) is provided.
• If you want to replace a programmed telephone number in the speed dial memory, you should follow the same steps as described
above to overwrite the number by a new telephone number.
Making a call
Select the speed dial number to which you have assigned the telephone number that you would like to call. J Press and hold the
corresponding digital button on the remote control for 2 seconds. J You will hear a triple beep tone and the corresponding telephone
number will be dialed.
Deleting all speed dial numbers
Switch off the power of the Blue Vision II by using the ON/OFF button (4). J Press and hold the Reject button (6) of the main unit and
press the ON/OFF button (4) for 1 second while pressing the Reject button (6). J You will hear a confirmation tone to indicate that the
speed dial list has been cleared. J Your Blue Vision II is now in ON position.