MGE UPS Systems EXB10Rack - Manual (Page 5)

MGE UPS SYSTEMS Pulsar EX Rack : 86-153522-00 iii
options
c UM Sensor environment measurement
unit: compatible with SNMP or Solution
Pac
TM , this unit measures the temperature
and the relative humidity in the room where
the Pulsar is installed. Eight relay contacts
are provided to transmit signals to an
administration platform, in the form of
voltage free contacts to enable monitoring of
(fire alarm, climate control fault, intrusion,
etc.);
c battery extension module: Pulsar
EXB10 Rack /EXB15 battery extension
modules lengthen the battery time of the
Pulsar EX10
Rack /EX15 Rack to meet your
requirements. For rack installation of EXB15
order 19" rack kit P/N 8806U.
additional communications
options:
c SNMP administration: MGE has the
most complete offering for the administration
of a group of UPSs using the SNMP protocol
with different network-connection modules
(SNMP card or proxy software), supervision
modules (application for NMS platforms
such as HP OpenView or C.A. UNICENTER
TNG) and a file-closing module (UM Client).
c SNMP card: this card, inserted into your
UPS, can establish a direct Ethernet network
connection for your UPS. It can then be
temporarily managed using SNMP or the
various software modules of Solution-Pac.
The MGE UPS SYSTEMS offering complies
with RFC 1628 specifications (IETF) and
was certified by the InterWorking Labs
during the Test Summit in June 1994;
c status information card: this option
provides you with 5 voltage-free contacts: on
battery, on by-pass, low battery, load on
UPS. This card can be used with the UPS
driver of IBM AS/400.
Contact your dealer for further information
on these options.