Matrox Electronic Systems Matrox RT.X2 - Manual (Page 54)

46
Chapter 3, Defining Your Adobe Premiere Pro Settings
Exporting to DV tape using DV-1394 device
control
You can use Matrox DV/HDV device control when exporting your Adobe
Premiere Pro sequence to a DV-1394 device. DV-1394 export to HDV, however,
is not supported for 720p projects.
° To export your sequence to tape over the 1394 interface:
1 Open the project and activate the sequence you want to export to tape.
2 Make sure your DV-1394 device is properly connected and turned on.
3 Unless you’re exporting to an HDV device, make sure that you’ve enabled
the DV-1394 output for export to tape and selected a DV-1394 output format
as explained in
“Selecting your DV-1394 output settings” on page 27 .
¦ Note If you’re exporting to an HDV device, Premiere Pro will detect that
you’re using an HDV device when you perform the export to tape and the
video will be exported in native HDV format. (Matrox RT.X2 SD does not
support exporting to an HDV device.)
4 If you’re using a camcorder, switch it to VTR mode.
5 Load a striped recordable tape into your DV-1394 device.
6 Make sure that you’ve set up Matrox DV/HDV device control as explained in
“Setting up Matrox DV/HDV device control” on page 44 .
7 Choose File > Export > Export to Tape .
For information about exporting your sequence to tape using Adobe Premiere
Pro, see your Adobe Premiere Pro documentation.